24—Using the Rhythm Track
320 www.Roland.com Roland VS-2000 Owner’s Manual
Each of the pattern’s notes is displayed as an event in the list you see onscreen, one
after another, in the order in which they play in the pattern.
2. To edit a note in the list, select its event using the
or
button—when an event’s
selected, it’s highlighted.
3. Press ENTER/YES to highlight the aspect of the event you wish to change.
Turn the Time/Value dial to change the selected event’s:
•
Position
—The note’s location in the pattern. You can edit its bar, beat and/or tick
value.
•
NOTE
—You can change the note being played by the selected event.
•
Vel
—You can set the note’s velocity, which controls its volume.
•
GATE
—You can set the duration of the note so that it’s shorter by adjusting its
beat or tick value. The default GATE time is 0-010, for 0 beats, 10 ticks.
4. To delete an event and its note altogether, select the note, or any of its parameters,
and press F4 (DELETE).
5. To add another note, select an event that’s playing as close as possible to the new
note you want to add, and then press F3 (INSERT). A copy of the selected event is
entered—adjust the event’s settings to position it, select the desired sound, and so
on.
6. To exit micro-editing, press F6 (EXIT).
Deleting a Pattern
To delete a user or project pattern you no longer want:
1. Navigate to the RHYTHM PATTERN SETUP screen.
2. If “PtnDel” isn’t visible above F2, press the PAGE button so it is.
3. Press F2 (PtnDel)—the RHYTHM PATTERN DELETE screen appears.
4. In the TARGET RHYTHM PATTERN area, select the desired pattern group, and
then the individual pattern you wish to erase. The selected rhythm pattern’s name
appears below the Group and No. parameters.
5. Press F5 (OK)—the VS-2000 asks if you’re sure. Proceeding with the operation will
permanently delete the selected pattern.
6. To finish deleting the pattern, press ENTER/YES.
You can’t remove a note from a pattern by setting its velocity to 0. See Step4 to learn
how to properly remove a note.
Setting GATE to a longer time value than the actual length of a drum sound has no
effect on the sound.
VS2000OMUS.book 320 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
