Roland VS-2000 - The TRACK;STATUS Buttons in Chrd Mode

25—Harmony
Roland VS-2000 Owner’s Manual www.RolandUS.com 333
The TRACK/STATUS Buttons in NOTE Mode, con’t.
The TRACK/STATUS Buttons in Chrd Mode
When Harmony creates a chord, it roots it on the TRACK/STATUS button note you
press after selecting the desired chord form with TRACK/STATUS Buttons 13-17/18.
TRACK/STATUS button #: Harmony Name: What it Does:
9G When both Oct buttons are lit, press
G to create a G harmony note above
Middle C, or G4. Otherwise, the
button plays a G in the selected
octave.
10 A When both Oct buttons are lit, press
A to create an A harmony note above
Middle C, or A4. Otherwise, the
button plays an A in the selected
octave.
11 B When both Oct buttons are lit, press
B to create a B harmony note above
Middle C, or B4. Otherwise, the
button plays a B in the selected
octave.
12 b/# • Press b/# once —it lights red and
changes the TRACK/STATUS
buttons so they play Cb-Bb.
• Press b/# twice —it lights green
and changes the TRACK/
STATUS buttons so they play C#-
B#.
13-17/18 min/maj;
7/maj7/6/9
sus4/aug; dim
The buttons do nothing in NOTE
mode.
You must install at least one optional VS8F-2 effect board to create Harmony chords,
and you must assign that board to Harmony (Page 328).
TRACK/STATUS button #: Harmony Name: What it Does:
1 and 2 -Oct. and + Oct. These two buttons work together.
When they’re both unlit, the TRACK/
STATUS buttons select chords in the
octave above Middle C. To change
octaves, press either button to turn it
on, shifting the pitch in the direction
of the lit button. To return to the
original octave, press the unlit button
so both buttons are unlit.
3Port. This button turns portamento on (lit)
or off (unlit) by changing the value of
the PORTAMENTO parameter—see
Page 330.
VS2000OMUS.book 333 ページ ２００４年１０月２０日 水曜日 午後３時３分