28—UTILITY Menu Parameters
Roland VS-2000 Owner’s Manual www.RolandUS.com 385
LOCATE
The LOCATE screen is described in “Editing Locators” on Page 184.
SCENE
To learn how to use the SCENE screen, see “Editing Scenes” on
Page 144.
AUTOMIX
See “The AUTOMIX Screen” on Page 342 to learn about using the
AUTOMIX screen.
DATE/TIME
To learn how to set the VS-2000’s calendar and clock that time-stamp
your recordings, see “Setting the VS-2000’s Clock” on Page 67.
Parameter Initialization
Use the MIXER/UTILITY PARAMETER INITIALIZE screen to reset many of the
VS-2000’s mixer and/or UTILITY menu parameters to their default factory settings. You
may want to do this to start over with a clean slate, or if your VS-2000 is behaving oddly,
and you suspect that some unknown parameter value may be the cause.
Resetting Mixer and UTILITY Parameters
1. Press UTILITY.
2. Press PAGE until “PrmIni” appears above F1.
3. Press F1 (PrmIni).
This screen doesn’t initialize all mixer and/or UTILITY menu settings. Your basic
project settings remain, including your current IDE drive selection. Scenes, the tempo
map and sync track, LOCATOR/SCENE TYPE, SHIFT LOCK and NUMERICS TYPE
parameters are among the settings that aren’t initialized.
VS2000OMUS.book 385 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
