Roland VS-2000 - Performing an Auto Punch

13—Operating the Hard Disk Recorder
192 www.Roland.com Roland VS-2000 Owner’s Manual
Performing an Auto Punch
1. Set your Auto Punch IN and OUT points as described above.
2. Press A.PUNCH so it’s lit.
3. Move to a convenient location in the project before the location you want to punch.
4. Press the track’s TRACK/STATUS button so it flashes red.
5. Press REC so it flashes red.
6. Press PLAY.
When the now line reaches the punch-in point recording automatically begins and
the TRACK/STATUS and REC buttons light solidly red. When the now line gets to
the punch-out point, recording automatically stops and the TRACK/STATUS and
REC buttons resume flashing.
7. To turn Auto Punch off, press A.PUNCH so it’s not lit.
VS2000OMUS.book 192 ページ ２００４年１０月２０日 水曜日 午後３時３分