Roland VS-2000 - Turning off the VS-2000

4—Setting Up and Basic Operations
Roland VS-2000 Owner’s Manual www.RolandUS.com 85
Turning Off the VS-2000
Turning Off the VS-2000
1. Hold down SHUTDOWN for two seconds. The following dialog appears:
2. If you wish to turn off or restart the VS-2000, press ENTER/YES. If not, press
EXIT/NO to cancel the operation. If you press ENTER/YES, a dialog like this one
appears:
3. If you’ve made changes to the currently loaded project you’d like to preserve, press
ENTER/YES. If you haven’t, press EXIT/NO.
In either case, the VS-2000 takes a few moments to prepare to shut down—and to
save your project if you pressed ENTER/YES in Step 3. When the VS-2000 is ready
to be powered off, the following message appears:
4. If you’d like to restart the VS-2000, hold down SHIFT and press the flashing PLAY
button—the VS-2000 begins its power-up sequence. If you’d like to shut down the
VS-2000, flip its rear-panel POWER switch to its Off position.
It’s important the you don’t simply flip the VS-2000’s POWER switch to turn it off—
always use the procedure below to prevent damage to your data.
If you’d like to restart the VS-2000—perhaps while troubleshooting a problem—use the
procedure below as well.
If you’re shutting down the VS-2000 when a factory demo song—or any other protected
project—is loaded, you won’t be prompted to store the current song.
If you need to move the VS-2000 after shutting it down, wait 30 seconds or so to give its
hard drive a chance to stop spinning in order to avoid damaging it.
The name of the
currently loaded project.
The project’s sample rate and
recording mode (Page 102).
VS2000OMUS.book 85 ページ ２００４年１０月２０日 水曜日 午後３時３分