25—Harmony
340 www.Roland.com Roland VS-2000 Owner’s Manual
Capturing a Harmony Snapshot
Record a Single Harmony Module’s Parameter’s Value
1. Move the now line to the desired location on either Harmony sequencer screen.
2. Press F6 (EXIT) and then F1 (Module).
3. Navigate to and select the desired common or part parameter that appears in the
list on Page 339.
4. Press F2 (TX Prm), for “Transmit Parameter.”
Record All Harmony Module Parameters At Once
1. Move the now line to the desired location on either Harmony sequencer screen.
2. Press F6 (EXIT) and then F1 (Module).
3. Press F3 (TX All), for “Transmit All Parameters.”
Recording Harmonies on Hard Disk Recorder Tracks
The final level and routing for each Harmony part is controlled by its same-numbered
FX return channel, as explained in “FX Return Channels” on Page 327.
To record a harmony part on a hard disk recorder track, route its FX return channel to
the track as described in “Routing Effects to Tracks” on Page 232. Set the FX return
channel’s level as desired to set the part’s level.
Turning the Harmony Feature Off
1. Press HARMONY.
2. Select the USE EFFECT BOARD parameter and turn the Time/Value dial counter-
clockwise to un-assign off each activate effect board.
3. Press HOME.
VS2000OMUS.book 340 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
