Roland VS-2000 - The Main FX Return CH EDIT Screen

17—Working with FX Channels
228 www.Roland.com Roland VS-2000 Owner’s Manual
The Main FX Return CH EDIT Screen
1. Press and hold the desired FX return channel’s FX button—its main CH EDIT
VIEW screen appears.
1. ASSIGN
The ASSIGN selector shows the FX bus that carries signals to the FX return
channel’s effect processor. This is also shown on the EZ ROUTING
EFFECT screen described on Page 279.
2. EFFECT Algorithm Display
The EFFECT algorithm display shows the algorithm on
which the effect’s currently selected patch is based. When
the display is selected, the ENTER/YES button flashes—
press the ENTER/YES button to jump to the effect’s
Algorithm View screen (Page 219).
3. MONO Sw
The MONO Sw (“Mono Switch”) allows you to collapse the left and right
sides of the stereo effect into a mono signal. To restore the effect to stereo,
turn Mono Sw off.
4. GROUP
You can assign the effect’s output to any of the VS-2000’s 12 fader groups that
allow you to control the levels of multiple input, track and/or FX return channels. The
parameter operates in exactly the same way as the input and track channel GROUP
parameter—see Page 153.
When the effect’s output is mono, you can use its BAL (Page 229) parameter to pan the
effect to the desired location.
7.
1.
2.
3. 4.
8.
6.
9.
11.
10.
12.
13.
14.
5.
VS2000OMUS.book 228 ページ ２００４年１０月２０日 水曜日 午後３時３分