29—Expanding the VS-2000
Roland VS-2000 Owner’s Manual www.RolandUS.com 395
Replacing the VS-2000’s Battery
The VS-2000 contains a lithium battery that powers its time-keeping features, and also
provides the power for the area of the VS-2000’s memory that stores certain parameter
values. When the battery weakens, the VS-2000’s time-keeping features may not
operate correctly, and it may not properly remember various settings upon power-up. If
the battery needs to be replaced, the VS-2000 shows the following message when you
power up:
Installation Procedure
1. Power down the VS-2000 (Page 85), saving any recent changes you’ve made to the
currently loaded project.
2. Turn off all connected devices, and disconnect all cables from VS-2000.
3. Turn the VS-2000 over onto its back, and remove only the screws shown in the
following illustration.
4. The battery should now be visible, as shown here.
Use only the specified type (model no. CR2032) of lithium battery. Be sure to insert it as
directed (to ensure correct polarity).
Before turning the VS-2000 upside-down to install a new battery, obtain some
newspapers or magazines and place them under the four corners of the VS-2000, or at
both ends, to prevent damage to the buttons and controls. Position the VS-2000
carefully to avoid scratching or damaging it.
When installing a new battery, follow the precautions listed on Page 389.
Lithium Battery
EFFECT C
EFFECT B
Tab
Should you remove battery and
screws, make sure to put them
in a safe place out of children’s
reach, so there is no chance of
them being swallowed
accidentally.
VS2000OMUS.book 395 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
