29—Expanding the VS-2000
396 www.Roland.com Roland VS-2000 Owner’s Manual
5. Replace the old battery with a new one.
■
Removal
■
Installation
6. Use the screws that you removed in Step 3 to re-fasten the VS-2000’s bottom cover.
This completes the process of exchanging the lithium battery.
7. Connect the cables that you disconnected earlier.
8. Turn on the power, as described in “Powering Up” on Page 65.
9. Confirm that the message saying the lithium battery is depleted no longer appears
in the display.
10. Reset the VS-2000’s clock and calendar (Page 67).
The VS-2000 uses a lithium CR2032 battery that you can purchase at most electronics
stores.
If you suddenly release your finger after pressing the lithium battery
inward, the battery may fly out in the direction shown by the arrow (see
illustration at right). Release your finger gradually, being careful not to
allow the battery to fall inside the unit.
The VS-2000’s clock is powered by its battery. Changing the battery may stop the clock
or cause it to display the wrong time or date.
1
2
While pressing the lithium battery
inward in the direction of the arrow...
1
2
Use your finger to tilt the battery
upward and slide it out.
1
2
While holding the lithium battery
at an angle, insert it in the direction
shown by the arrow.
1
2
Press the battery down until it
is retained by the tabs.
VS2000OMUS.book 396 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
