Roland VS-2000 - Clearing Loop Points; Setting Loop Points Using Locators; Setting Loop Points Using Markers; Editing Loop from and to Points Manually

13—Operating the Hard Disk Recorder
Roland VS-2000 Owner’s Manual www.RolandUS.com 179
Clearing Loop Points
1. Hold down LOOP and CLEAR and press the FROM or TO button to clear the
current LOOP FROM or TO point, respectively.
Setting Loop Points Using Locators
You can learn about locators on Page 182. The following steps presume you’ve already
placed locators at the beginning and end of the section you want to loop.
1. Press LOCATOR•SCENE—so it’s lit—and select the locator bank containing the
locators you’ve placed at the start and end of the section you want to loop.
2. Recall the locator positioned at the start of the section.
3. Hold down LOOP and press FROM.
4. Recall the locator positioned at the end of the section.
5. Hold down LOOP and press TO.
Setting Loop Points Using Markers
Markers are described on Page 186. Before setting your Loop FROM and TO points,
place markers at the beginning and end of the section to be looped.
1. Move to the marker located at the start of the section.
2. Hold down LOOP and press FROM.
3. Move to the marker located at the end of the section.
4. Hold down LOOP and press TO.
Editing Loop FROM and TO Points Manually
You can edit, clear and place Loop Punch FROM and TO points on the AUTO PUNCH/
LOOP screen in the UTILITY MENU.
1. Hold down SHIFT and press LOOP—the AUTO PUNCH/LOOP screen appears.
You can do a few things with your Auto Punch IN and OUT points on this screen:
•You can use the cursor buttons and Time/Value dial, or a connected mouse, to
change either point’s location by time code or measures and beats.
•You can select FROM or TO on the screen and press F2 (CLEAR) to erase its
current time assignment.
•You can grab the now line’s current position as a new FROM or TO point. Select
FROM or TO on the screen and click F3 (GetNow).
•You can move the now line to an FROM or TO location by selecting FROM or
TO on the screen and clicking F4 (GO TO).
2. Press EXIT when you’re done to confirm your changes.
Loop IN time
Loop OUT time
VS2000OMUS.book 179 ページ ２００４年１０月２０日 水曜日 午後３時３分