23—MIDI and Synchronization
304 www.Roland.com Roland VS-2000 Owner’s Manual
Exchanging Digital Audio Data During Synchronization
You can exchange digital audio between the VS-2000 and its sync partner. You might, for
example, want to move audio tracks from one V-Studio to another. To learn about digital
connections, see Page 48. To learn about clocking digital audio, see Page 135.
When the VS-2000 is the Master
Set the VS-2000’s MASTER CLOCK parameter (Page 135) to INT to send digital audio to
the slave device with the VS-2000 controlling the audio’s timing.
When the VS-2000 is the Slave
You can receive digital audio from the master device by setting the VS-2000’s MASTER
CLOCK to DIGITAL IN. The received digital audio’s clocking is computed from, and
controlled by, the master device’s time code.
You can also send digital audio from the VS-2000 to the master device by setting the
VS-2000’s MASTER CLOCK parameter to INT—with this setting, the VS-2000
generates its own master clock based on the time code received from the master device.
VS2000OMUS.book 304 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
Need help?
General
