28—UTILITY Menu Parameters
382 www.Roland.com Roland VS-2000 Owner’s Manual
Digital
MASTER CLOCK
To learn about setting the MASTER CLOCK parameter, see “Designating the Master
Clock for Digital Audio Input” on Page 136.
DITHER
If you’re sending audio to a connected external digital recorder that records at a lower
bit depth than the VS-2000 (Page 135), you can dither the VS-2000’s output signal so that
it sounds its best at the bit depth the external device is using. Dithering adds an
inaudible veil of noise to the signal in order to mask audio artifacts that are introduced
when bits are discarded as audio travels from a higher bit-rate device to a lower one. To
set DITHER, select the bit depth of the external digital device.
DIGITAL COPY PROTECT
The VS-2000 allows you to use SCMS (“Serial Copy Management system”) to prevent
additional copies from being made of digital audio you’ve recorded from the VS-2000’s
coaxial or optical digital outputs onto a DAT tape or MiniDisc. To prevent copying, turn
the DIGITAL COPY PROTECT parameter on before sending the digital audio to the
DAT or MiniDisc recorder.
Display
Turn off DITHER until it’s needed since it affects all audio transmitted from the
VS-2000’s digital outputs, including the audio sent to your connected Roland
DS-series Digital Reference Monitors.
VS2000OMUS.book 382 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
