28—UTILITY Menu Parameters
Roland VS-2000 Owner’s Manual www.RolandUS.com 383
DISPLAY OFFSET TIME
This parameter is explained in “Shifting the Project Start Time” on Page 300.
TIME DISPLAY FORMAT
This parameter is explained in “Shifting the Project Start Time” on Page 300.
PEAK HOLD Sw
You can set the VS-2000’s level meters so that their peak lines “stick” at their highest
positions, remaining there until you press HOME to release them. This allows you to
look away from the display without worrying that you’ll miss problematic level peaks.
To make the peak lines stick, set PEAK HOLD Sw to On. To return them to their normal
behavior, turn the parameter off.
PLAYREC
RECORD MONITOR
RECORD MONITOR is explained in “Monitoring During Punching” on Page 189.
MARKER STOP
MARKER STOP lets you set the hard disk recorder so it automatically stops when the
now line reaches the next marker. This can be handy when you want to stop playback at
the end of a section you’re working on: place a marker at the desired location and turn
on this parameter. When MARKER STOP is off, the recorder behaves normally.
FADE LENGTH
You can set the length of the crossfade that smooths transitions when you record,
punch in and out, and edit. You can select 2ms, 10ms, 20ms, 30ms, 40ms or 50ms. The
default setting is 10ms.
SCRUB LENGTH
This parameter is explained in “Setting Scrub Times” on Page 182.
UTILITY menu
F4 (PlyRec)
VS2000OMUS.book 383 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
