Roland VS-2000 - Adding Effects to a Headphone MIX

17—Working with FX Channels
234 www.Roland.com Roland VS-2000 Owner’s Manual
6. To break the connection, repeat Steps 3 and 4, and turn the Time/Value dial
counter-clockwise until no connection exists.
Adding Effects to a Headphone Mix
When you’ve created a headphone mix using an Aux bus, it’s easy to add an effect to
any of its signals. Send each channel’s signal to the effect as desired. The following
steps describe how to route the effect to the Aux bus:
1. press and hold down the FX 1-6 button for the FX return channel belonging to the
effect you want to send to the headphone mix. The FX return channel CH EDIT
parameters appear.
2. Set the Send Status parameter for the Aux bus you’re using for your headphone mix to
its available Pre or Post value, depending on the Aux bus’s configuration (Page 206).
3. Set the amount of the effect to be sent to the headphone mix.
To clear all FX effect-to-track connections, press PAGE until “ClrTrA” appears above F4,
and then press F4 (ClrTrA).
For the effect to sound its best, use a linked pair of Aux busses for a stereo headphone
feed. In Steps 4 and 5 above, you’ll be setting up both linked Aux busses
simultaneously—use the linked Aux busses’ balance control to position the stereo
effect as desired in the mix.
You can also set the send level using the VS-2000’s CH PARAMETERS SENDS knob—
see “CH PARAMETERS Controls” on Page 167.
Aux 1’s
Send Status
parameter
VS2000OMUS.book 234 ページ ２００４年１０月２０日 水曜日 午後３時３分