16—Using Effects
Roland VS-2000 Owner’s Manual www.RolandUS.com 225
RSS PAN
The VS-2000’s RSS Pan effect adds a rich three-dimensionality to stereo
audio signals, offering intelligent control of the size and even the
placement of the sound in the listening space.
Up to four channels’ signals can be sent to the RSS Pan effect.
To Configure the RSS Pan Feature:
1. Hold down SHIFT and press F4.
2. Press PAGE repeatedly until “RSSPan” appears above F2.
3. Press F2 (RSSPan)—the RSS PAN SETUP screen appears:
4. Cursor to the Use EFFECT Board parameter and turn the Time/Value dial to select
the effect board you’d like to use for producing the RSS Pan effect. You can select
Off—for no RSS Pan—or VS8F-2 A or B.
5. Press ENTER/YES to confirm your selection.
6. If you’d like to hear RSS Pan in your PHONES jack, turn the PHONES Sw on.
7. To select the first channel to which you’d like to apply RSS Panning. cursor down to
the top line in the USE CHANNEL LIST box and turn the Time/Value dial to select
the desired input or track channel.
8. To send additional channels’ signals to the RSS Pan effect, cursor to the other lines
in the Use CHANNEL LIST box and turn the Time/Value dial to select the desired
channel or channels.
RSS Pan can be used only with unlinked channels.
The RSS Pan effect requires the use of one of the VS-2000’s effect boards. When the
board is allocated to RSSPan, it can’t be used for other effects or the analyzer.
You can use the B effect board only if your VS-2000 has two VS8F-2s installed.
You can also assign channels to the RSS Pan effect directly from their CH EDIT screens,
as described on Page 155.
To record a signal with RSS Pan applied, route the RSS effect to the desired pair of
tracks on the EZ Routing ROUTING VIEW screen. When RSS Pan is turned on “RSS”
replaces “1” and “2” in the FX RTN block onscreen.
VS2000OMUS.book 225 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
