Roland VS-2000 - Editing Locators; Locators in Safe Mode; Other Locator Operations; Remaining in Locator Mode

13—Operating the Hard Disk Recorder
184 www.Roland.com Roland VS-2000 Owner’s Manual
Other Locator Operations
Editing Locators
You can edit locators on the UTILITY menu’s LOCATE screen. You can name them,
clear them, create them, change their positions and jump to them from this screen.
1. Hold down SHIFT and press F4.
2. Press PAGE repeatedly until “LOCATE” appears over F3.
3. Press F3 (LOCATE).
4. Press  or  or turn the Time/Value dial to select the desired locator. You can:
• press F1 (NAME) to rename (Page 74) the selected locator.
• press F2 (CLEAR) to delete the selected locator.
• press F3 (GetNow) to reset the locator to the now line’s current position.
• Press F4 (GO TO) to move the now line to the selected locator’s position.
5. Press F6 (EXIT) when you’re done to confirm your changes.
Remaining In Locator Mode
You can set the VS-2000 so that it remains in Scene mode after recalling and storing
scenes, or so it automatically returns to Locator mode after either action.
1. Hold down SHIFT and press F4.
2. If you don’t see “SYSTEM” above F1, press PAGE until you do.
3. Press F1 (SYSTEM).
4. If F1 (Param1) isn’t highlighted, press F1 (Param1).
5. You can set the Rtn TO Tr STATUS Sw parameter to:
• On —to automatically leave Locator mode after you store, recall or clear a
locator, returning the TRACK/STATUS buttons to their usual job.
• Off —to remain in Locator mode after storing, recalling or clearing a locator.
6. Press F6 (EXIT) to confirm your changes.
Locators in Safe Mode
If you prefer to work with locators a bit more slowly and carefully, you can use Safe
mode. Safe mode allows you to work with locators in a LOCATOR window that shows
each locator’s number and name. You can also store and clear locators in Safe mode.
While this is a slower way to work, it provides greater certainty that you’ve got the right
locator.
You can store a new locator at the now line’s current position by scrolling to an unused
locator line and pressing F3 (GetNow).
VS2000OMUS.book 184 ページ ２００４年１０月２０日 水曜日 午後３時３分