18—Editing Tracks
Roland VS-2000 Owner’s Manual www.RolandUS.com 249
Editing from the TRACK Menu
You can perform any phrase or region editing operation from the
TRACK menu. To display the TRACK menu:
1. Hold down SHIFT and press F2 (TRACK).
How the TRACK Menu Is Organized
The TRACK menu presents all phrase and region editing operations in two sub-menus:
•The TRACK PHRASE EDIT MENU • The TRACK REGION EDIT MENU
The large PHRASE and REGION symbols that appear at the right side of the screen tell
you at a glance which menu is currently displayed.
The Appearance of TRACK Menu Screens
TRACK menu screens, as shown above, don’t fill the entire display—parts of the Home
screen remain visible to make editing easier. You can move around a project using the
current time location display (Page 130). The playlist is visible in most edit screens. The
meters display—or the fader/pan displays—may also remain in view.
Sources and Destinations in the TRACK Menu
When you’re moving or copying phrases and regions, or if you’re swapping regions on
different tracks in the TRACK menu, designate the:
•
source track
—the track you’re moving or copying audio from.
•
destination V-Track
—the track to which you’re moving or copying the audio.
The parameters unique to each phrase or region editing operation are described in
Chapters 19 and 20, respectively.
If you’re viewing: Switch to the: By pressing:
TRACK PHRASE EDIT MENU TRACK REGION EDIT MENU
F6 (Ph
→
Reg)
TRACK REGION EDIT MENU TRACK PHRASE EDIT MENU
F6 (Reg
→
Ph)
You can also select the desired menu by pressing PHRASE•REGION•AUTOMIX on
your connected VGA monitor until it turns green for phrase editing or red for region
editing.
When the playlist is visible during editing, you can hold down SHIFT and press F5 to
replace the playlist with the wave display.
+
VS2000OMUS.book 249 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
