Roland VS-2000 - Navigating to the Mastering Room; Selecting the Mastering Room Operating Mode; Selecting the Mastering Tracks Recording Mode; Turning on the Mastering Room

27—Mastering and CD-R/RW Operations
Roland VS-2000 Owner’s Manual www.RolandUS.com 359
Working in the VS-2000 Mastering Room
Navigating to the Mastering Room
1. While holding down SHIFT, press CD-RW. The MASTERING
ROOM screen appears.
Turning On the Mastering Room
To turn on the Mastering Room:
1. Set the MASTERING ROOM on/off switch to On.
2. To de-activate the Mastering Room, set its switch to Off.
Selecting the Mastering Room Operating Mode
The Mastering Room’s operating mode is determined by the setting of its STATUS
parameter. You can select:
• Play —to play back already recorded mastering tracks.
• Record —to record new mastering tracks.
Selecting the Mastering Tracks’ Recording Mode
When the CDR Rec Mode parameter is turned on, your mastering tracks are recorded
as disk image files that can be immediately burned to an audio CD (Page 356). When it’s
turned off, the mastering tracks are recorded using the project’s recording mode.
Typically, you’ll want to set CDR Rec Mode to On.
When the Mastering Room is turned on, the CD-RW button flashes.
+
Mastering room
parameters
Project playlist
Navigation buttons
VS2000OMUS.book 359 ページ ２００４年１０月２０日 水曜日 午後３時３分