Roland VS-2000 - Exporting Tracks and Phrases as WAV Files; Exporting Tracks as Wav Files

27—Mastering and CD-R/RW Operations
372 www.Roland.com Roland VS-2000 Owner’s Manual
Exporting Tracks and Phrases as WAV Files
If you want to move audio from a project to an external device—such as a computer or
sampler—that reads WAV files, you can export any track or phrase as a WAV file. The
exported audio is written onto a data CD.
When you want to export an entire track, use the Track Export feature. To export
portions of a track, use the VS-2000’s phrase editing tools to fashion the audio into a
phrase, and use the Phrase Export feature.
The procedures for exporting tracks and phrase start a bit differently, but end on the
the same CD-burning screen.
Exporting Tracks as WAV Files
1. Insert a blank CD-R or CD/RW into your CD burner.
2. On the CD-RW MASTERING MENU screen (Page 364), press F5
(TrkExp) for “Track Export”—the TRACK EXPORT Select Track screen
appears.
On this screen, you see a list of all of the project’s V-Tracks. To the right is a V-Track
map that shows you which V-Tracks contain data. When you export a track as a
WAV file, you’re really exporting a V-Track—see Chapter 6 for an explanation of the
relationship between tracks and V-Tracks.
You can select the V-Tracks you want to export on TRACK EXPORT’s Select Track
screen or on its V-Track Map screen, described on the next page. You can mark as
many V-Tracks for export as you want on either screen.
3. To select a V-Track for export on the Select Track screen, turn the Time/Value dial to
highlight the V-Track and press F4 (MARK) to place a checkmark next it. You can
toggle on or off the selection status of all V-Tracks that contain data by pressing F3
(ALL)—this can be handy if you want to export all of your tracks as WAV files.
Since most audio programs can read WAV files, you can process exported VS-2000
audio using virtually any audio processing or editing software. Afterwards—and after
saving the result as a WAV file—you can re-import the audio back into the VS-2000.
The VS-2000 exports each pair of linked tracks as a stereo WAV file.
Turning the Time/Value dial takes you through each of the project’s V-Tracks. Hold
down SHIFT as you turn to jump between same-numbered V-Tracks on different tracks.
F5 (TrkExp)
V-Tracks
Read-only
V-Track Map
VS2000OMUS.book 372 ページ ２００４年１０月２０日 水曜日 午後３時３分