23—MIDI and Synchronization
302 www.Roland.com Roland VS-2000 Owner’s Manual
When V-LINK mode is turned on, the following parameters are automatically set in
preparation for V-LINK mode operation.
1. SYNC Parameters
•
SYNC AUTO
—is set to On.
*1
2. MIDI Parameters
•
MIDI OUT/THRU
—is set to Out.
•
SysEx. Tx Sw
—is set to On.
•
SysEx. Rx Sw
—is set to On.
3. FADER Assign Parameters:
• Determined by the setting of the parameters on the UTILITY V-LINK screens.
See Page 386.
4. AUTOMIX is also turned on.
*2
•Automix can control a variety of V-LINK parameters, as listed in the “Automix
Parameter List” on Page 408.
*1 The setting of this item changes only if the Sync Parameter screen SYNC MODE is set to “EXT.”
*2 The setting of this item changes only if the Sync Parameter screen SYNC MODE is set to “INT.”
Switching V-LINK Mode Off
1. Press the VS-2000’s V-LINK button.
V-LINK will go dark, and V-LINK mode will be turned off.
Connecting the VS-2000 and the DV-7PR
When you use the VS-2000 together with the Edirol DV-7PR’s “Presenter,” you can:
• make the necessary Edirol DV-7PR settings from the VS-2000.
• use the VS-2000’s faders to control video playback.
• use the VS-2000’s Automix feature for the synchronized rolling of video and sound
on the Edirol DV-7PR.
1. Make sure that the power of all devices is turned off, and make the connections
shown on the next page.
The V-LINK function is compatible with DV-7PR’s “Presenter” version 1.5 or later.
Before connecting the VS-2000 to other devices, turn off the power to all of the devices.
This will help prevent malfunctions and/or damage to speakers or other devices.
VS2000OMUS.book 302 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
