Roland VS-2000 - Page 303

23—MIDI and Synchronization
Roland VS-2000 Owner’s Manual www.RolandUS.com 303
2. Turn on the power of each device.
3. Start up the Edirol DV-7PR “Presenter.”
4. Hold down SHIFT and press F4.
5. If “SYNC” isn’t visible above F6, press PAGE until it is.
6. Press F6 (SYNC)—the SYNC PARAMETER screen appears.
7. Set SYNC MODE to INT.
8. Press the VS-2000’s V-LINK button—the VS-2000 asks for confirmation.
9. Press ENTER/YES.
V-LINK mode is turned on, and the V-LINK button lights.
The Edirol DV-7PR can now be operated from the VS-2000.
When operating the Edirol DV-7PR, the “Select a Clip Bank” operation listed in the
V-LINK Function Chart corresponds to switching the palette.
Hold down CLEAR and press V-LINK to initialize the parameters of the connected
video device. For details on the initialized value of each video device parameter, refer to
the owner’s manual for your video device.
For details on the MIDI messages transmitted in V-LINK mode, refer to “MIDI
Implementation” (“VS-2000 Appendices”).
Display
Projector
MIDI OUT
REMOTE
Edirol DV-7PR
VS-2000
Edirol UM-1 series
VS2000OMUS.book 303 ページ ２００４年１０月２０日 水曜日 午後３時３分