21—Working with the VS-2000 0utputs
274 www.Roland.com Roland VS-2000 Owner’s Manual
Output Signal Routing
You can route bus signals or track signals to the VS-2000’s analog and digital outputs.
We’ll discuss these two topics separately.
Bus Routing
The VS-2000’s output jacks and connectors can transmit MASTER, MONITOR, Aux
and Direct path signals from the VS-2000’s outputs to external devices. With the
exception of the MASTER and MONITOR analog outputs, you can route any pair of
busses—or a stereo bus—to any pair of output jacks or connectors.
•The MASTER analog jacks always carry the stereo MASTER bus signal.
•The MONITOR analog jacks always carry the stereo MONITOR bus signals—you
can, however, send the signals from any pair of busses into the stereo MONITOR
bus feeding the MONITOR jacks.
Routing a Pair of Busses to a Pair of Outputs
1. Press EZ ROUTING.
2. If “OUTPUT” isn’t above F3, press PAGE repeatedly until it is.
3. Press F3 (OUTPUT)—the OUTPUT ASSIGN screen appears.
The output jack and connector pairs run along the top of the screen, and the bus
pairs run up and down its left edge.
4. Use
or
to select the desired pair of output jacks or digital connectors.
5. Turn the Time/Value dial to choose the desired pair of busses to be routed to the
selected output pair—as you turn the dial, the connection box moves up and down
the display, showing you what’s routed to the selected pair of outputs.
Though busses are routed to outputs in pairs, you can send completely different signals
on each bus pair’s odd/even busses. If you’re using Aux busses, the busses can be
linked in stereo (Page 206) or not, as desired.
If you prefer, you can route busses to outputs by dragging an output pair’s connection
box down to the desired bus pair with your mouse.
The coaxial and optical digital outputs are always active, and carry the same signal.
In this illustration, we’ve
selected the Aux analog
jacks.
Aux Busses 1 and 2 are
routed to the Aux jacks, as
shown by the thick black
connection line.
Each bus runs from left to right
across the display. When you
select an output and turn the
Time/Value dial, a connection
box moves down the screen to
reach the desired bus.
VS2000OMUS.book 274 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
