23—MIDI and Synchronization
286 www.Roland.com Roland VS-2000 Owner’s Manual
Every move you make on the VS-2000 produces a SysEx message that’s transmitted
from the MIDI OUT/THRU jack to the external MIDI device.
To receive SysEx Data from an external MIDI device:
1. Using a MIDI cable, connect the VS-2000 MIDI IN jack to the MIDI OUT jack of the
device from which you want to receive SysEx data.
2. Navigate to the MIDI parameter screen (Page 283).
3. Turn on SysEx. Rx Sw so that the VS-2000 responds to received SysEx data.
Changing Scenes via MIDI
You can send the VS-2000 Program Change values on MIDI Channel 16 to recall scenes
in the current project. Program Change Numbers 00-95 recall Scenes 01-96.
Changing Effect Patches via MIDI
You can remotely select effect patches by sending the VS-2000 the appropriate Bank
Select and Program Change messages on the effect’s MIDI channel. Effects 1-6 respond
to messages received on MIDI Channels 1-6, respectively.
Remote Control of the VS-2000 with Control Change Messages
You can set a variety of VS-2000 parameters from a remote MIDI device by sending the
VS-2000 Control Change messages. These include:
• input, track, FX return channel parameters • Aux and Direct path
parameters
• MASTER and MONITOR bus parameters • effect parameters
You can also send the VS-2000 Control Change messages to set its hard disk recorder’s
TRACK/STATUS buttons.
You can record the SysEx data on a track in a sequencer you’re synchronizing with the
VS-2000, as discussed later in this chapter.
The VS-2000 can’t switch scenes while its hard disk recorder is playing back. When it
receives a Program Change on MIDI Channel 16 during playback, playback pauses, the
requested scene is recalled, and playback then resumes.
Received Program Changes on MIDI Channel 16 are ignored during recording.
Bank MSB (C.C. 0): Bank LSB (C.C. 32): Program Change Numbers: Selects Patches:
00 0-99 Preset 000-099
01 0-99 Preset 100-199
02 0-49 Preset 200-249
03 0-99 User 000-099
04 0-99 User 100-199
You can change effect patches using program changes sent to the VS-2000 when the
hard disk recorder is playing, recording or stopped.
VS2000OMUS.book 286 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
