24—Using the Rhythm Track
Roland VS-2000 Owner’s Manual www.RolandUS.com 313
Deleting a Rhythm Arrange
You can delete a user or project rhythm arrange to save disk space, as follows:
1. Press RHYTHM TRACK to display the RHYTHM TRACK screen.
2. If “DELETE” isn’t visible above F2, press the PAGE button so it is.
3. Press F2 (DELETE)—the RHYTHM ARRANGE DELETE screen appears.
4. In the TARGET RHYTHM ARRANGE area, select the desired rhythm arrange
group, and then the individual rhythm arrange you wish to erase. The selected
rhythm arrange’s name appears below the Group and No. parameters.
5. Press F5 (OK)—the VS-2000 asks if you’re sure. Proceeding with the operation will
permanently delete the selected rhythm arrange.
6. To finish deleting the rhythm arrange, press ENTER/YES.
Working with Rhythm Patterns
About the RHYTHM PATTERN SETUP Screen
All rhythm pattern recording and editing work starts on the RHYTHM PATTERN
SETUP screen when you select a pattern.
Temporary Pattern Memory
The pattern you choose is automatically copied into a special area of temporary
memory within the VS-2000. Any changes to make to the pattern—including recording
new data or editing the pattern—are applied to this temporary copy, and its name
changes so it starts with “TEMP” to reflect this. When you’re satisfied with your work,
you can save the pattern in the user or project Rhythm Track memory.
You can listen to the selected pattern on the pattern setup screen, pattern recording
screens or micro edit screen
If you wish to preserve a pattern you’re working on, save it to user or project memory
before selecting another pattern or powering down the VS-2000. When you select
another pattern or turn off the VS-2000, the pattern held in temporary memory—and
therefore your work—is replaced or cleared, respectively. See “Saving a Rhythm
Pattern” on Page 319.
VS2000OMUS.book 313 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
