Roland VS-2000 - Configuring a Direct Path

15—FX and Aux Busses and Direct Paths
Roland VS-2000 Owner’s Manual www.RolandUS.com 209
Configuring a Direct Path
Each Direct path can receive signals from an input, track or FX return channel before or
after—pre or post—the channel’s fader level control. Generally, you’ll want to use the
post-fader send, though the pre-fader send can be handy when you’re using a Direct
path for adding an insert-like external effect to a channel’s signal (Page 208).
1. Hold down SHIFT and press CH EDIT•MASTER.
2. Set the Direct path’s Pre/Pst switch to the desired value.
3. Adjust the final level parameter at the bottom of its control
strip.
The SRC readout shows the input or track channel signal
currently assigned to the Direct path.
+
Eight master
control strips for
the eight Direct
paths
Pre-Pst
switch
SRC
channel
Final level control
VS2000OMUS.book 209 ページ ２００４年１０月２０日 水曜日 午後３時３分