Roland VS-2000 - Editing Scenes

10—Using the Digital Mixer
144 www.Roland.com Roland VS-2000 Owner’s Manual
help you get right back to recording. You can change this behavior if you wish so that
Scene mode remains active—and LOCATOR•SCENE button remains lit red—until you
manually leave it.
1. Hold down SHIFT and press F4.
2. If you don’t see “SYSTEM” above F1, press PAGE until it you do.
3. Press F1 (SYSTEM).
4. If F1 (Param1) isn’t highlighted, press F1 (Param1).
5. You can set the RETURN TO Tr STATUS Sw parameter to:
• On —to automatically re-activate the TRACK/STATUS buttons after you store or
recall a scene.
• Off —so that you must press LOCATOR•SCENE to leave Scene mode.
6. Press F6 (EXIT) to confirm your changes.
Editing Scenes
You can edit scenes on the UTILITY menu’s SCENE screen. You can name them, clear
them, store and recall them, and select the channels whose settings are to be recalled.
1. Hold down SHIFT and press F4.
2. Press PAGE repeatedly until “SCENE” appears above F4.
3. Press F4 (SCENE).
4. Press  or  or turn the Time/Value dial to select the desired scene. You can:
• Press F1 (NAME) to rename (Page 74) the selected scene.
• Press F2 (CLEAR) to delete the selected scene.
• Press F3 (STORE) to store your current settings as the selected scene.
• Press F4 (RECALL) to recall the selected scene.
• Press F5 (Ch Sel) to protect channels when scenes are recalled—see Page 145.
5. Press F6 (EXIT) when you’re done to confirm your changes.
Save a new scene by selecting a blank location in the list and pressing F3 (STORE).
The VS-2000 time-
stamps each scene when
it’s created, as shown on
this screen.
VS2000OMUS.book 144 ページ ２００４年１０月２０日 水曜日 午後３時３分