Roland VS-2000 - Loading an EZ Routing Template

22—EZ Routing
282 www.Roland.com Roland VS-2000 Owner’s Manual
Loading an EZ Routing Template
1. Press EZ ROUTING.
2. If “LOAD” isn’t visible above F5, press PAGE until it is.
3. Press F5 (LOAD)—the EZ ROUTING TEMPLATE LOAD screen appears.
4. Turn the Time/Value dial to select the template you want to load.
5. Press F5 (OK). The VS-2000 asks if you’re sure you want to proceed.
6. Press ENTER/YES to load the template, or EXIT/NO to cancel the operation. If you
press ENTER/YES, the template—and all of the routings and configuration settings
it contains—loads.
Before loading an EZ Routing template, it’s a good idea to turn your listening level
down all the way in case the template’s new connections and settings cause feedback,
result in unwanted noises or cause other problems.
VS2000OMUS.book 282 ページ ２００４年１０月２０日 水曜日 午後３時３分