Roland VS-2000 - EZ ROUTING VIEW Screen; Making Connections on the Ez Routing View Screen; The EZ ROUTING OUTPUT ASSIGN Screen

22—EZ Routing
278 www.Roland.com Roland VS-2000 Owner’s Manual
EZ ROUTING VIEW Screen
The EZ ROUTING VIEW screen shows—and allows you to interconnect—all of your:
• input channels • FX busses • Aux busses
• MASTER bus • Direct paths • track channels
• FX return channels • hard disk recorder tracks
Making Connections on the EZ ROUTING VIEW Screen
1. Use  ,  ,  or  to select the desired input or output connection. You can select:
• input channel outputs • FX and Aux bus outputs
• MASTER bus outputs • Direct path outputs
•Track channel outputs • FX return channel outputs
2. Turn the Time/Value dial to create the desired connection.
We’ve already described various EZ ROUTING VIEW connections in detail in other
parts of the VS-2000 Owner’s Manual .
The EZ ROUTING OUTPUT ASSIGN Screen
On the EZ ROUTING OUTPUT ASSIGN screen, you can route any of the VS-2000’s
busses to output jacks or connectors.
To learn how to route: See:
input channels to tracks for recording Page 172
track channels to tracks for bouncing Page 196
FX return channels to tracks for recording and bouncing Page 233
Input channel outputs
Hard disk recorder
track inputs
Track channel outputs
Aux, FX and
MASTER busses
Direct paths
FX return
channel outputs
The gray arrows at
the left edge of the
screen show the
direction in which
signal is flowing.
Outputs
Busses
VS2000OMUS.book 278 ページ ２００４年１０月２０日 水曜日 午後３時３分