Roland VS-2000 - 11 Input and Track Channel Tools; Viewing a CH EDIT Screen; Changing Ch Edit Screens; Displaying a Track Channels Ch Edit Screen

Roland VS-2000 Owner’s Manual www.RolandUS.com 147
11—Input and Track Channel Tools
Input channel and track channels offer almost exactly the same parameters with which
you can shape their signals. This chapter describes these “CH EDIT”—short for
“Channel Edit”—parameters. They have their own chapter since they’re the main tools
you use to make your input signals and tracks sound the way you want.
Viewing a CH EDIT Screen
Displaying an Input Channel’s CH EDIT Screen
1. Press the desired channel’s button in the INPUT area.
Displaying a Track Channel’s CH EDIT Screen
1. Press CH EDIT so it lights. if it isn’nt already lit.
2. Press the desired track channel’s TRACK/STATUS button.
Changing CH EDIT Screens
1. To view a specific CH EDIT screen whose F button is currently:
• visible —press the screen’s F button.
• hidden —press PAGE, and then press the screen’s F button.
Input channel CH EDIT settings affect how a signal will be recorded. Track channel
CH EDIT changes affect only how the hard disk recorder plays a track, and are
therefore less permanent. If you’re not sure about a change you’re thinking of making
to a signal you’re about to record, make the changes in its track channel.
FX return channels have their own CH EDIT parameters. However, they’re a little bit
different than the CH EDIT parameters discussed here—you can learn about them in
Chapter 17.
CH EDIT
button
TRACK/STATUS
buttons
VS2000OMUS.book 147 ページ ２００４年１０月２０日 水曜日 午後３時３分