13—Operating the Hard Disk Recorder
Roland VS-2000 Owner’s Manual www.RolandUS.com 191
Setting Auto Punch Points Using Locators
You can learn about locators on Page 182. The following steps presume you’ve already
placed locators at the desired punch-in and -out locations.
1. Press LOCATOR•SCENE—so it’s lit green—and, if necessary, select the locator
bank containing the locators you want to use as punch-in and punch-out points.
2. Recall the locator positioned at the start of the section you want to punch.
3. Hold down A.PUNCH and press IN.
4. Recall the locator positioned at the end of the section you want to punch.
5. Hold down A.PUNCH and press OUT.
Setting Auto Punch Points Using Markers
Markers are described on Page 186. Before setting your Auto Punch In and OUT points,
place markers at the desired punch-in and -out locations.
1. Move to the marker located at the desired punch-in location.
2. Hold down A.PUNCH and press IN.
3. Move to the marker positioned at the end of the section you want to punch.
4. Hold down A.PUNCH and press OUT.
Editing Auto Punch IN and OUT Points Manually
You can edit, clear and place Auto Punch IN and OUT points on the AUTO PUNCH/
LOOP screen in the UTILITY MENU.
1. Hold down SHIFT and press A.PUNCH to view the AUTO PUNCH/LOOP screen.
You can do a few things with your Auto Punch IN and OUT points on this screen:
•You can use the cursor buttons and Time/Value dial, or a connected mouse, to
change either point’s location by time code or measures and beats.
•You can select IN or OUT on the screen and press F2 (CLEAR) to erase its
current time assignment.
•You can grab the now line’s current position as a new IN or OUT point. Select
IN or OUT on the screen and click F3 (GetNow).
•You can move the now line to an IN or OUT location by selecting IN or OUT on
the screen and clicking F4 (GO TO).
2. Press EXIT when you’re done to confirm your changes.
Auto Punch IN time
Auto Punch OUT time
VS2000OMUS.book 191 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
