Roland VS-2000 - Recording Digital Input Signals

9—Working with Input Signals
Roland VS-2000 Owner’s Manual www.RolandUS.com 137
Recording Digital Input Signals
Before you can record signals received by the VS-2000’s digital COAXIAL IN jack, you
have to enable digital recording on the VS-2000. Here’s how:
1. Hold down SHIFT and press F4.
2. Press PAGE until “SYSTEM” appears above F1.
3. Press F1 (SYSTEM).
4. Press  ,  ,  and/or  to highlight the CD DIGITAL REC parameter if necessary.
5. Turn the Time/Value dial to select On.
The “Concerning Copyright” statement appears as a reminder of the laws
governing the digital copying of copyrighted materials. It also presents Roland’s
position on the SCMS digital recording copy-protection protocol.
6. After reading the statement, press ENTER/YES, or press EXIT/NO to suspend
activation of digital recording.
If you pressed ENTER/YES in Step 6, the VS-2000 licensing agreement appears.
7. If you agree to the displayed terms, press ENTER/YES. If not, press EXIT/NO to
leave digital recording disabled.
Since the CD DIGITAL REC parameter is a system parameter, it doesn’t need to be re-
set unless you initialize your VS-2000’s system settings (Page 385).
If this screen isn’t visible
after you press F1
(SYSTEM), press F1
(Param1) to display it.
VS2000OMUS.book 137 ページ ２００４年１０月２０日 水曜日 午後３時３分