18—Editing Tracks
Roland VS-2000 Owner’s Manual www.RolandUS.com 247
1. Press HOME and use the
,
,
and/or
buttons to set the display’s
magnification as desired.
2. To prepare to trim:
•
the front of a phrase
—hold the mouse cursor over the
phrase’s leading edge until the trim in cursor appears.
•
the back of a phrase
—hold the mouse cursor over the
phrase’s trailing edge until the trim out cursor appears.
3. To trim:
•
the front of the phrase
—click and drag to the right.
•
the back of the phrase
—click and drag to the left.
4. Release the mouse button to execute the trim.
Snapping to Grid
When you’ve set up a tempo map (Page 296) for your project, you can turn on the Home
screen’s Track Edit Grid feature.
When the grid is active, the front edge of a phrase or region you’re dragging “snaps” to
the nearest gridline as you drag. You can have a gridline for every measure or beat. To
place the audio at the gridline, release the mouse button after the snap. If you’re
dragging a group of phrase or regions, the first one you select snaps to the grid, and the
others retain their positions relative to that first phrase or region.
To turn on the Track Edit Grid feature:
1. Right-click on the Home screen’s playlist.
2. Select GRID from the Edit Pop-Up menu——the Grid Options window opens.
3. Select the desired grid setting. You can select:
•
Off
—so the grid is turned off.
•
Measure
—for a gridline at the start of every measure.
•
Beat
—for a gridline for every beat in the project.
•
1/2, 1/4, 1/8, 1/16, 1/32
—for a gridline at each selected beat division.
If you select any value other than Off, the grid appears immediately in
the playlist.
You can snap any edit point to a gridline by setting the UTILITY menu’s SYSTEM GRID
MODE parameter (Page 380) as desired. To:
•
snap only TO edit points to gridlines
—set GRID MODE to Only TO.
•
snap all edit points to gridlines
—set GRID MODE to ALL EDIT POINT.
You can drag a phrase’s edge as far as the beginning or end of the take on which the
phrase is based, and no further.
If you can’t see the grid, hold down SHIFT and press
or
to zoom in or out until the
gridlines appear.
You can temporarily disable the grid feature by holding down CLEAR on the
VS-2000 as you drag edit points or audio.
Trim out
Trim in
This illustration shows
measure gridlines.
VS2000OMUS.book 247 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
