13—Operating the Hard Disk Recorder
Roland VS-2000 Owner’s Manual www.RolandUS.com 183
Storing a Locator
1. Press LOCATOR•SCENE if it’s not already lit green.
Each locator bank contains 16 memory slots, numbered from 1-16, in which a
locator can be stored. These memory slots correspond to the 16 TRACK/STATUS
buttons. When a locator’s been stored in a slot, its TRACK/STATUS button lights
when you’re in Locator mode and its locator bank is selected.
2. Press any TRACK/STATUS button to store the locator in the corresponding
memory slot. If you’d like to store the locator in a different locator bank, see
“Changing Locator Banks” and press the desired TRACK/STATUS button in the
selected bank.
3. If a memory slot already contains a locator, and you want to store a new locator
there, you’ll have to first clear the older locator. See “Clearing a Locator” below.
Recalling a Locator
1. Press LOCATOR•SCENE if it’s not already lit green.
2. If the currently selected locator bank contains the locator you want, press the
locator’s lit TRACK/STATUS button. To recall a locator from another bank, follow
the instructions in “Changing Locator Banks” and press its TRACK/STATUS button
in the selected bank.
Changing Locator Banks
1. Press LOCATOR•SCENE if it’s not already lit green. If any locators are stored in the
currently selected locator bank, their TRACK/STATUS buttons light.
2. Hold down LOCATOR•SCENE for two seconds—the LOCATOR BANK SELECT
window appears.
3. Turn Time/Value dial to select the desired locator bank.
4. Press ENTER/YES to change locator banks.
Clearing a Locator
1. Press LOCATOR•SCENE if it’s not already lit green. If you’d like to clear a locator
from a different bank, see the instructions in “Changing Locator Banks” first.
2. While holding down CLEAR, press the desired locator’s TRACK/STATUS button.
The locator is cleared from that memory slot, and the button’s light turns off.
You can store locator’s while a project’s playing or when it’s stopped.
After the locator is recalled, the VS-2000 remains Locator mode. You can change this
behavior if you wish—see “Remaining In Locator Mode” on Page 184.
After the locator is recalled, the VS-2000 leaves Locator mode. You can change this
behavior if you wish—see “Remaining In Locator Mode” on Page 184.
VS2000OMUS.book 183 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
