Roland VS-2000 - Configuring the VS-2000; Setting up the VGA Monitor, Mouse and Keyboard

4—Setting Up and Basic Operations
66 www.Roland.com Roland VS-2000 Owner’s Manual
Configuring the VS-2000
Setting Up the VGA Monitor, Mouse and Keyboard
Here’s how to set up the mouse, keyboard and VGA monitor you can
use when you’ve installed a VS20-VGA VGA/Mouse Expansion Board
board (purchased separately):
1. Hold down SHIFT and press F4 under the display.
2. Press PAGE—if necessary—until “SYSTEM” appears above F1.
3. Press F1 (SYSTEM) beneath the display.
4. Press F3 (Param3) to display the VGA, mouse and keyboard settings.
5. Use the  ,  ,  and  buttons as necessary to select each setting—a setting’s
outline darkens when it’s selected—and turn the Time/Value dial to choose the
desired value.
If you don’t have a VGA monitor, mouse or keyboard, skip over its parameters.
VGA Monitor Parameters
Mouse Parameters
ASCII Keyboard Parameters
Parameter: What it sets: Typical setting is:
VGA OUT Turns the VGA output on or off On
REFRESH RATE Sets the rate at which the monitor
re-draws its image
Manufacturer’s
recommended setting
H. POSITION Shifts the image left or right 0
V. POSITION Shifts the image up or down 0
OPERATION
TARGET
Designates the internal LCD or a
connected VGA monitor as the main
operation display
see Page 381
Consult your VGA monitor’s documentation for its recommended refresh rate to avoid
poor image quality and possible damage to the monitor.
The VGA parameters are described in greater detail on Page 381.
Parameter: What it sets: Typical setting is:
PS/2 MOUSE Turns the mouse on or off On
POINTER SPEED Sets how fast the mouse’s cursor
moves
3
MOUSE BUTTON
SWAP Sw
Sets the right- or left-handedness of
the mouse
( see Page 70 )
Parameter: What it sets: Typical setting is:
PS/2 KEYBOARD Turns the keyboard on or off On
KEYBOARD TYPE Selects the nationality of the ASCII
keyboard you’re using
101/104 (in USA);
106/109 (Japan)
+
VS2000OMUS.book 66 ページ ２００４年１０月２０日 水曜日 午後３時３分