Roland VS-2000 - Page 171

12—Working with Input Channels
Roland VS-2000 Owner’s Manual www.RolandUS.com 171
To Quick-Route an Input Signal to a Track
1. Make sure the CH EDIT button isn’t lit—if it is, press the button to un-light it.
2. Hold down the desired track channel’s TRACK/STATUS button for a second or so
until the QUICK ROUTING screen appears.
The TRACK/STATUS button you held down in Step 2 lights solidly to show the
current destination track. If any input channels are already routed to the track, their
SELECT buttons also light solidly.
3. Press the desired input channel’s INPUT button—a virtual wire appears on the
screen to show the connection you’ve made.
4. If you want to break the connection press the INPUT button again.
5. To route another signal to the track, repeat Step 3, if necessary, and Step 4.
6. To select another destination track, press the desired track’s TRACK/STATUS
button—it lights solidly to show that it’s now the Quick Routing destination track.
7. Repeat Steps 3 and 4 to select the input channel signal you want to send to the
track.
8. When you’ve finished, press F6 (EXIT) to confirm your routing and leave Quick
Routing mode.
To quickly clear all track routings, hold down the solidly-lit TRACK/STATUS button
and press CLEAR. or simply press F4 (AllClr).
Input
Channels
1-10
Hard Disk
Recorder
Tracks 1-18
In this illustration,
we’ve cleared all
connections for visual
clarity. When you
create a new project,
Input Channels 1-10
are already routed to
Tracks 1-10.
We selected
Track 1. It
flashes to show
it’s selected.
The gray arrows at the
left edge of the screen
show the direction in
which signal flows.
We pressed
Input Channel
1’s INPUT
button
VS2000OMUS.book 171 ページ ２００４年１０月２０日 水曜日 午後３時３分