14—Working with Track Channels
Roland VS-2000 Owner’s Manual www.RolandUS.com 197
4. Turn the Time/Value dial clockwise—as you turn it, a wire appears that connects the
track channel to one track after another in the Recording Track block.
5. Turn the dial in either direction to select the desired destination track.
6. To break the connection between a track channel and a track, repeat Steps 3 and 4,
and turn the Time/Value dial counter-clockwise until no connection exists.
7. Repeat Steps 3-5 to route other track channels’ outputs to the destination track.
To clear all track-to-track connections, press PAGE until “ClrTrA” appears above F4,
and then press F4 (ClrTrA).
We’ve selected linked
stereo Tracks 9 and
10 as our destination.
We’ve connected a
combination of mono and
stereo source track channels
to our stereo destination
linked tracks.
Source Tracks 1 and 12 are
mono track channels, and
Track Channels 17 and 18
are linked in stereo.
VS2000OMUS.book 197 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
