26—Automix
Roland VS-2000 Owner’s Manual www.RolandUS.com 343
The AUTOMIX STATUS Area
In the AUTOMIX STATUS area, select each Automix
track and turn the Time/Value dial to set it as
desired. The appearance of each Automix track’s box
shows you its current status.
An Automix track can be set to:
•
Manual
—so the corresponding input, track, Aux master or FX return channel,
MASTER fader or Direct path doesn’t use Automix. Its parameters are set
manually.
•
Write
—so that the Automix track records changes made to the corresponding
input, track, Aux bus or FX return channel, MASTER fader or Direct path.
•
Read
—so that the Automix track plays back its recorded Automix data.
Saving and Loading Multiple Automixes
Each project can store up to nine separate, alternate Automixes, any one of which can
be loaded at any time. With multiple Automixes available, you can:
•develop the perfect automated mixdown through multiple versions with the ability
to return to an earlier version at any time by simply re-loading it.
• try out several Automix approaches to a project and pick the one you like best.
•Automix the same project in different ways for different uses.
To save an Automix:
1. Press F4 (SAVE)—the AUTOMIX PATTERN SAVE screen appears. It shows the
nine memory locations into which Automixes (or Automix “patterns”) can be saved.
2. Highlight the memory location into which you want to save the current Automix.
3. Press F5 (OK)—the VS-2000 asks “Save Automix Pattern?”
4. Press ENTER/YES to proceed or EXIT/NO to cancel the save.
If you select a location that already contains an Automix, the Automix you’re saving
replaces the one that’s already stored there.
To name a saved Automix, highlight it and press F1 (NAME). To learn how to use the
VS-2000 naming tools, see “Naming” on Page 74.
The Automix track is set to:
Manual
Write
Read
VS2000OMUS.book 343 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
