Roland VS-2000 - Page 350

26—Automix
350 www.Roland.com Roland VS-2000 Owner’s Manual
MOVE
Automix MOVE allows you to move already-recorded Automix data to a new location
on the same Automix track or to another Automix track. You’d most often use MOVE
when you’ve changed the position of track audio and need to move its automation to
the same location.
INSERT
Insert adds an area of blank space at the IN location equal to the length of the selected
Automix region—all data at the IN point and onward is moved so that it starts at the
end of the inserted blank space. When you’ve inserted empty space in an audio track,
you’ll want to insert space in the accompanying Automix track as well so that your
Automix events line up properly with their corresponding audio data.
CUT
CUT deletes the Automix events between the IN and OUT points and moves the
remaining data forward so that it starts at the IN point. You might cut Automix data
when it occurs just a bit later than you want it to, or when you need to re-align it with
audio you’ve moved forward in the project.
Edit point: What it does:
FROM sets the location of the Automix data region’s time anchor
TO sets the destination location for the time anchor
When you copy Automix data to a new location, it replaces any Automix data already
present in the destination location.
Edit point: What it does:
FROM sets the location of the Automix data region’s time anchor
TO sets the destination location for the time anchor
When you move Automix data to a new location, it replaces any Automix data already
present in the destination location.
Before After
OUT TOIN OUT TOIN
FROM is set to
the same
location as IN.
Before After
OUTIN
OUTIN
Before After
OUTIN OUTIN
VS2000OMUS.book 350 ページ ２００４年１０月２０日 水曜日 午後３時３分