2—Getting Around
36 www.Roland.com Roland VS-2000 Owner’s Manual
3—CH PARAMETERS Controls
The controls in the CH PARAMETERS section allow you to quickly adjust important
settings in the currently selected input or track channel. When the channel’s settings
are displayed, the top four knobs control dynamics or EQ settings. To set the behavior
of the knobs, press the DYNAMICS or 4 BAND EQ buttons.
The SENDS knob controls the amount of signal the channel sends to the selected Aux
or FX bus, as described on Page 167.
The RSS/PAN knob can control the channel’s stereo panning or the amount of its signal
sent to the VS-2000’s RSS Pan 3D effect (Page 225). When the channel is:
•
not being sent to the RSS Pan effect
—the knob controls the position of the channel’s
signal in the MASTER bus main mix.
•
being sent to the RSS Pan effect
—the knob controls the amount of signal going to the
RSS effect.
4—HARMONY Button
Press the HARMONY button to view the HARMONY ASSIGN screen on which you
can set up the VS-2000’s automatic harmonization feature.
5—TRACK/STATUS Buttons 1-18
The TRACK/STATUS 1-18 buttons perform a variety of tasks on the VS-2000, according
to the state of the CH EDIT, HARMONY, RHYTHM TRACK, LOCATOR•SCENE and
SOLO•MUTE buttons. When:
•
CH EDIT, HARMONY, RHYTHM TRACK, LOCATOR•SCENE and SOLO•MUTE are not
lit
—the TRACK/STATUS buttons set the behavior of the corresponding hard disk
recorder track(s). See Page 176.
•
CH EDIT is lit
—press a TRACK/STATUS button to select the corresponding track
channel and display its settings. See Page 147.
•
HARMONY is lit
—press a TRACK/STATUS button to select the desired harmonic
mode or interval. See Page 325.
•R
HYTHM TRACK is lit
—you can create and edit patterns by performing the desired
notes on the TRACK/STATUS buttons. See Page 305.
•
LOCATOR•SCENE is lit
—green, you can use the TRACK/STATUS buttons to store
and recall locators (Page 182). When it’s lit red, you can use the TRACK/STATUS
buttons to store and recall scenes (Page 142).
•
SOLO•MUTE is lit
—green, the TRACK/STATUS buttons flash to allow you to solo
individual tracks in SOLO mode (Page 142). When it’s lit red, they flash to let you
mute individual tracks in Mute mode (Page 141).
When: DYNAMICS is lit: 4 BAND EQ is lit:
Low G•Threshold sets the volume threshold at
which dynamics processing
takes place.
sets the level, or “gain,” of the
Low EQ band.
Low-Mid G•Attack sets the speed at which
dynamics processing starts.
sets the gain of the Low-Mid
EQ band.
Hi-Mid G•Release sets the speed at which
dynamics processing stops.
sets the gain of the Hi-Mid
EQ band.
High G•Level sets the level of the dynamics
processor’s signal.
sets the gain of the High EQ
band.
VS2000OMUS.book 36 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
