27—Mastering and CD-R/RW Operations
Roland VS-2000 Owner’s Manual www.RolandUS.com 367
9. Select the mastering tracks—or other pair of tracks—
you want to burn on the CD. You can select these in
either of two ways. To select your tracks:
•
at the same time
—select the L-Ch SOURCE TRACK
parameter and turn the Time/Value dial to select
the same-numbered V-Tracks on any odd/even
pair of project tracks.
•
individually
—select a pair of V-Tracks using the
L-Ch SOURCE TRACK parameter, and then use
the R-Ch SOURCE TRACK parameter to select a
different right-side V-Track.
10. Select the desired WRITING METHOD: Track at Once
or Disk at Once (see Page 364).
11. Set Finalize (Page 365) as desired. You can set it to:
•
Off
—Use this setting when you’re burning audio on a Track at Once CD, and
you’ll to be adding more audio later.
•
On
—Use this setting when you’re burning a Disk at Once CD, or when you’re
adding the last selection to a Track at Once CD.
•
OnlyFin. (“Only Finalize”)
—Use this setting when you’ve decided you’re done
adding selections to a TAO CD, but haven’t yet finalized the CD.
12. Select the speed at which the burner is to write the CD. You can select any of the
available speeds—you’ll only be offered choices supported by your burner.
13. Press F5 (OK) to begin burning the CD.
The VS-2000 asks if you’re sure you want to burn the disk with your current
settings, and if you’ve remembered to place the CD’s track markers:
Audio CD-R Write Sure?
(selected writing method)
CD Track No. OK?
14. If you wish to proceed, press ENTER/YES. To cancel the operation, press EXIT/NO.
15. The VS-2000 displays a message about copyrighted material. When you’ve read the
message, press ENTER/YES, or press EXIT/NO to cancel the operation.
16. A screen appears that discusses licensing terms. If you agree to these terms, press
ENTER/YES to proceed. Otherwise, press EXIT/NO to cancel the operation.
If you press ENTER/YES, the VS-2000 proceeds to burn the CD.
When it’s finished, the VS-2000 asks if you’d like to burn another CD of the same
audio material. If you do, insert a new CD in your burner and press ENTER/YES, or
press EXIT/NO to complete your CD-burning session.
17. If you press EXIT/NO, the VS-2000 displays “Done!”
If you lack the required space on the CD—or on your hard drive, as in Step 8—press F6
(CANCEL). If the CD is blank and still won’t hold your audio, you’ll need to trim the
audio so that it fits. If the CD has other selections on it already, consider starting a new
CD. If you need to make a disk image and don’t have enough room on your hard drive,
you’ll need to clear some space on the drive before proceeding.
If you select Track at Once, make sure to use a CD-R disk. You
can’t write a Track at Once CD-RW disk.
Try using the highest available speed to make the burning operation as brief as
possible. If you have trouble burning the CD, try a lower speed.
You can easily spot a
V-Track recorded in CDR
mode—it has an asterisk in
its number instead of a
hyphen.
CDR-recorded V-Tracks
Standard V-Tracks
VS2000OMUS.book 367 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
