Roland VS-2000 - Page 387

28—UTILITY Menu Parameters
Roland VS-2000 Owner’s Manual www.RolandUS.com 387
FADER 1-17/18
A variety of settings on a V-LINK-connected video device can be controlled using the
VS-2000’s faders when V-LINK is active and FADER ASSIGN Sw (see above) is turned
on. To assign a fader to the control of a setting, select the corresponding FADER
parameters and dial in:
• No Assign —to de-activate the fader for V-LINK control.
• Playback Speed —to adjust the video playback speed. The amount of change depends
on the setting of the PLAYBACK SPEED RANGE parameter (see above).
• Dissolve Time —to specify the time over which a dissolve (overlap) will occur when
switching between clips.
• Color Cb —to adjust the blue hues.
• Color Cr —to adjust the red hues.
• Brightness —to adjust the brightness of the image.
• T Bar —to gradually switch video clips using the fader.
VS2000OMUS.book 387 ページ ２００４年１０月２０日 水曜日 午後３時３分