Roland VS-2000 - Page 391

29—Expanding the VS-2000
Roland VS-2000 Owner’s Manual www.RolandUS.com 391
7. After powering up the VS-2000, hold down SHIFT and press F3 (EFFECT).
8. Verify that the VS8F-2/VS8F-3 are installed correctly. If they are installed correctly,
the effects corresponding to the EFFECT B/C section(s) will be displayed as follows.
• VS8F-2: An effect icon will be displayed.
• VS8F-3: The screen will indicate <PLUG-IN>
* The VS8F-3 will not be recognized unless system software that supports plug-in effects
has been installed. Refer to the VS8F-3 owner’s manual for details.
If the effect produced by an installed VS8F-2/VS8F-3 is missing—and the screen shows
“No EFFECT Board” instead—the VS-2000 is not correctly recognizing the VS8F-2/
VS8F-3. Re-install the VS8F-2/VS8F-3.
INTERNAL EFFECT
EFFECT B
EFFECT C
VS2000OMUS.book 391 ページ ２００４年１０月２０日 水曜日 午後３時３分