4—Setting Up and Basic Operations
64 www.Roland.com Roland VS-2000 Owner’s Manual
Install a VS20-VGA and Connect a PS/2 Mouse and ASCII Keyboard
A mouse and ASCII keyboard can make operation of the VS-2000 even easier. When
you install a VS20-VGA VGAMouse Expansion Board (purchased separately), the
VS-2000 supports the use of a PS/2-type mouse and keyboard. (A PS/2 mouse and
keyboard must be purchased separately.)
Many of the VS-2000’s operations can be performed using a mouse instead of the
VS-2000’s top-panel controls, as described on Page 70. A mouse also allows you to
operate the VS-2000 from the screen of a connected VGA monitor (purchased
separately)—see Page 381. You can perform a wide range of operations—and navigate
the VS-2000—using a connected ASCII keyboard (Page 72).
Connect the included mouse and keyboard to a PS/2 “Y” connector—
available at most computer supply stores—attached to the
VS20-VGA’s PS/2 MOUSE jack.
Install a VS20-VGA and Connect a VGA Monitor
When you connect a color VGA monitor (purchased separately) to a VS20-VGA
(purchased separately) installed in your VS-2000, the VS-2000 becomes even easier to
use. By manipulating its controls onscreen using your mouse, everything becomes a
simple matter of pointing and clicking. You can use the VGA as your main display and
the VS-2000’s internal LCD as a supplemental Info Display, or the other way around.
See Page 381 to learn more.
You can use any standard VGA display that has a refresh rate from 60-75 Hz. Connect
your monitor’s DB-15-type VGA cable to the VS20-VGA’s VGA OUT jack.
Connect Monitors or Headphones
The connections you’ll make depend on how you’ll be listening to the VS-2000:
• If you’re going to be listening to the VS-2000 through DS-series monitors, you can
connect the VS-2000’s COAXIAL OUT to the monitors’ COAXIAL DIGITAL INPUT.
Make sure the DS-90’s or DS-50A’s Digital Input Select Switch is set to COAXIAL,
and that its Input Select Switch is set to DIGITAL INPUT. See your
DS
-series
Owner’s Manual
for more information.
• If you’re using other monitors, connect the VS-2000’s MONITOR L and R jacks to
the left and right inputs, respectively, of your speaker system.
• If you’re using headphones, connect them to the PHONES jack.
Connect All Other Devices
Connect any other devices to the appropriate VS-2000 jacks or connectors. If you’re
unsure which jack or connector to use, consult the device’s documentation.
You may need to activate your ASCII keyboard. See the keyboard
settings on Page 66
When using the COAXIAL OUT for monitoring, you’ll need to configure the
VS-2000 as described in “If You’re Using DS-Series Monitors” on Page 75.
VS2000OMUS.book 64 ページ ２００４年１０月２０日 水曜日 午後３時３分
To Next Page
Loading...
