Configuration Guide GSN Configuration
[no] security { [v1 | v2] community
community | v3 user username }
Set the security name for the smp server
communication. This command supports
snmp v1、v2、v3. By default, the security
community is not configured.
The command security v1 community
and security community are both used to
configure the v1 user. If you need to
configure v3 user, the snmp-server
command shall be used. See the SNMP
Configuration.
[no] smp-server host ip-address
Set the IP address for the SMP server.
When configuring the security v3 user, the corresponding v3 user shall be
configured.
Configuring the Minimum Security Event Interval
To prevent the illegal users from faking the security event and frequently sending the
security events to attck the security switch and SMP, you can set the minimum
interval to notify the security event.
Run the following commands to set the minimum security event interval.
Enter the global configuration mode.
[no] security event interval interval
Set the minimum security event interval.
Interval: 1-65535s;
By default, the interval is 5s.
This example shows the priority value configuration process:
Ruijie(config)# cpu-protect type bpdu pri 7
Set packet type bpdu priority 7.
Enabling the Security Address-bind on the Interface
The SMP server IP address and the security authentication name must be configured
to implement the community between the SMP servers.
To Next Page
Loading...
