Ruijie RG-S2900G-E Series - Page 709

Configuration Guide NFPP Configuration
Command
Function
Ruijie# clear nfpp ip-guard hosts [vlan
vid] [interface interface-id] [ip-address]
clear nfpp ip-guard hosts: Clear all
isolated hosts.
clear nfpp ip-guard hosts vlan vid:
Clear all isolated hosts in a VLAN.
clear nfpp ip-guard hosts [vlan vid]
[interface interface-id]: Clear all
isolated hosts on a interface in a VLAN.
clear nfpp ip-guard hosts [vlan vid]
[interface interface-id] [ip-address]: An
isolated host has been cleared. Use the
IP address to identify the hosts.
Showing ip-guard
 Showing ip-guard configuration
 Showing monitored host configuration
 Showing trusted host configuration
Showing ip-guard configuration
Use this command to show the ip-guard configurations.
Command
Function
Ruijie# show nfpp ip-guard summary
Show the ip-guard configurations.
For example,
Ruijie# show nfpp ip-guard summary
（Format of column Rate-limit and Attack-threshold is per-src-ip/per-src-
mac/per-port.）
Interface Status Isolate-period Rate-limit Attack-threshold Scan-thresh
old
Global Enable 300 4/-/60 8/-/100 15
G 0/1 Enable 180 5/-/- 8/-/- -
G 0/2 Disable 200 4/-/60 8/-/100 20
Maximum count of monitored hosts: 1000
Monitor period：300s