Configuration Guide RSPAN Configuration
Ruijie(config-Vlan)# exit
Return to the global configuration mode.
Configuring the Destination Switch
Destination Port
The remote RSPAN device forwards the mirrored packets received from the Remote
VLAN to the monitoring device through the destination port.
Destination port features:
The destination port can be switched port, routed port or AP.
The destination port can be set to enable or disable communications.
Communicatios is disabled by default. Under default configuration, neither the
packets from other ports nor the packets from CPU are forwarded.
Configuration Steps
Ruijie# configure terminal
Enter the global configuration mode.
Ruijie(config)# vlan vlan-id
Enter the VLAN configuration mode.
Ruijie(config-Vlan)# remote-span
Set the VLAN as remote-span Vlan.
Ruijie(config-Vlan)# exit
Return to the global configuration mode.
Ruijie(config)# monitor session session_num
remote-destination
Configure the remote mirroring destination.
Ruijie(config)# monitor session session-num
destination remote vlan vlan-id interface
interface-name [switch]
Configure Remote VLAN and the remote
mirroring destination port.
switch indicates the destination port joins
switching.
Ruijie(config)# interface interface-name
Enter the remote mirrorring destination port.
To Next Page
Loading...
Need help?
General