Sakura Tissue-Tek Polar DM User Manual

1-40
Setting the Cleaning Operation (Defrost Cycle/Ozone
cycle) Start Time
1. Press the "Schedule" button on the [UTILITIES] Tab Screen.
2. Select the "Always-on operation" selector button.
3. Press the cleaning operation start time "Set" button.
4. The defrost cycle start time change screen appears.
5. Set the starting hours and minutes.
Press the value you want to change, and the value will be
selected and highlighted.
6. To change the hours, press the value of hours.
Press the ""/"" buttons among the "Value Change" buttons
to change the value of hours. In the case of 24-hour display,
hours is displayed in a range of 0 to 23 and minutes, as a
multiple of 15 minutes. In the case of 12-hour display, hours is
displayed in a range of 1 to 12 and minutes, as a multiple of 15
minutes, with am/pm also shown.
7. Pressing the “Enter” button saves the setting, after which the
display returns to the [UTILITIES] Tab Screen.
If no operation has been performed for 5 minutes, the setting is
not saved and the screen closes automatically.
If scheduled operation has been selected by the corresponding
"Operation Selector" button, the defrost cycle and ozone cycle (if
set) is started at the operation end time.
The cleaning operation requires about 3 hours to finish.
Pay attention to the cleaning operation start time when setting it.
Schedule button
Always-on operation
selector button
Cleaning operation start
time setting button
Currently set hours
Currently set minutes
Value change button
(up/down)
Enter
button
When setting time,
am/pm is shown in the
case of 12
-hour format.

Sakura Tissue-Tek Polar DM Specifications

General

Brand	Sakura
Model	Tissue-Tek Polar DM
Category	Medical Equipment
Language	English