Commissioning with Terminal PR 5610 Installation Manual
144 Sartorius
5.7.3.3 Digital module testing
The test can be executed for PR 1713/12, PR 1713/15 and PR 1713/17.
PR1713 Rel. 03.12 20.05.2004 09:05
Test PR1713/12 Slot-Number 3
Inputs: I1= 1 I2= 0 I3= 1 I4= 1
Outputs: Dec: 11 Hex: B Bin: 1011
Set Outputs:
D Decimal-Input-Format for Output-Value
H Hexadecimal-Input-Format for Output-Value
S Set Bit Bit-Nr. 0..n
R Reset Bit Bit-Nr. 0..n
E Exit
♦ Display of slot number
The slot number is displayed in the mask header:
Test PR 1713/12 Slot-Number 3
♦ Display of the actual digital input values
The actual values are displayed:
Inputs: I1= 1 I2= 0 I3= 1 I4= 1
♦ Entry of output values
Entry of the values for the outputs (e.g. 4 in PR 1713/ 12 and 1713/15) is possible in various formats.
Selection is by entry of the relevant letter.
Set all outputs simultaneously:
• Decimal input format
D Decimal-Input-Format for Output-Value
• Hexadecimal entry
H Hexadecimal-Input-Format for Output-Value
Setting/ resetting individual outputs:
• Set a bit, bit no. 0…n
S Set Bit Bit-Nr. 0 … n
• Reset a bit, bit no. 0…n
R Reset Bit Bit-Nr. 0 … n
Example for dialogue line for setting a bit:
Enter Bit-Number for Set: 3
♦ Display of output values
Display is in three formats. See the following mask line:
Outputs:
• Decimal
Dec: 11
• Hexadecimal
Hex: B
• Binary (MSB left, LSB right)
Bin: 1011
♦ Leave mask 'Test PR 1713/12' with
E Exit
After leaving this mask (E), return is to the sub-menu.
Test Inputs/Outputs:
The entered output values remain set until returning to menu 'Service'.
To Next Page
Loading...