Schweitzer Engineering SEL-351P - Factory EZ Settings

Settings
36 SEL-351P Quick-Start Installation and User's Guide (Portuguese)
Factory EZ Settings
The SEL-351P ships with the factory EZ settings shown in Table 8. The
corresponding number references provide a quick way to find the
settings (or subsettings) in the Settings Descriptions subsection that
follows.
The reference to Settings Groups 1 and 2 at the top of
Table 8 refers to
the two choices for the active setting group:
Settings Group 1 = main settings
Settings Group 2 = alternate settings
Refer to the Operator Controls subsection in the Front-Panel Interface
section (AJUSTES ALTERNATIVOS operator control pushbutton) for
more information on how to switch between these two setting groups. In
the factory EZ settings, these two setting groups are set the same.
The Global EZ settings at the end of
Table 8 apply to both settings
Groups 1 and 2.
Those factory settings indicated with an asterisk (*) in
Table 8 are
hidden with these particular factory settings. As a general rule, if a main
setting is set to N, then the subsettings that follow are hidden. The
following Settings Descriptions subsection explains the details behind
hiding the settings. Complete setting ranges are also given in the
Settings Descriptions subsection.
!
WARNING: Anytime an EZ setting is changed, review all the EZ settings
before enabling the new settings. Pay close attention in circumstances where
a setting was once set to OFF or N and then later turned on (enabled) – other
related settings may need to be turned on, though may still be set to OFF or N.
View EZ Settings With
Commands:
SHO EZ 1 (Group 1)
SHO EZ 2 (Group 2)
SHO FZ (Global)
See Table 2 in the
Communications section.
Set EZ Settings With
Commands:
SET EZ 1 (Group 1)
SET EZ 2 (Group 2)
SET FZ (Global)
See Table 2 in the
Communications section.