10-48 Serial Port Communications and Commands Date Code 990430
SEL-351P Manual Técnico
group n. n specifies the settings group (1, 2, 3, 4, 5, or 6);
n defaults to the active settings group if not listed.
SET P n Change serial port settings. n specifies the port (1, 2, 3, or
F); n defaults to the active port if not listed.
SET R
Change sequential events recorder (SER) settings.
SET T
Change text label settings for the front panel display
points.
The SET EZ n and SET FZ commands are available from Access Level E (EZ), too.
See Table 9.1 for settings sheet references. See subsection Settings Changes via the Serial Port
in Section 9: Setting the SEL-351P Recloser Control for more setting command information.
STA C Command (Status Clear Command)
The recloser control latches all mainboard self-test warnings and failures in order to capture
transient out-of-tolerance conditions. To reset the self-test status, use the STA C command:
=>>STA C <ENTER>
The control responds:
Reboot the relay and clear status
Are you sure (Y/N) ?
If you select “N” or “n”, the control displays:
Canceled
and aborts the command.
If you select “Y”, the control displays:
Rebooting the relay
The control then restarts (just like powering down, then powering up control), and all diagnostics
are rerun before the recloser control is enabled.
Refer to Table 13.1 in Section 13: Testing and Troubleshooting for self-test thresholds and
corrective actions.
VER Command (Show version information)
The Version command, VER, allows you to view information about the recloser control battery
charger board firmware versions. The response to the VER command has the following format:
FID=SEL-351P-Rxxx-Vx-Dxxxxxx
0351P-x Wye Integral Battery Charger
To Next Page
Loading...